Why Flushing Matters
Minerals settle at the bottom of the tank as sediment. Over time this layer makes the heater louder, slower and less efficient. A yearly flush washes much of it out.
What You Need
- A garden hose that reaches a drain or outside
- A flat screwdriver or the drain valve handle
- Gloves, because the water is hot
Flushing Step by Step
- Turn the gas valve to pilot, or turn off power at the breaker for electric units.
- Close the cold water valve on top of the tank.
- Attach the hose to the drain valve and run it outside or to a floor drain.
- Open a hot water tap in the house, then open the drain valve.
- Let it drain, then open the cold valve for a minute to stir and rinse sediment.
- Close the drain, refill the tank fully, then turn gas or power back on.
When Not to Do It Yourself
If the drain valve is plastic and old, it may break or not close again. If the tank has never been flushed in many years, heavy sediment can clog the valve. In those cases, let a plumber handle it.
Check the Anode Rod Too
Inside most tank heaters is a metal rod called an anode. It wears away so the tank does not rust. In hard water it can wear out in just a few years. If the rod is mostly gone, a new one can add years to the tank. It takes a large socket and some muscle, so many people let a plumber check it during a yearly flush.
Need a Pro Flush or Repair?
We flush, repair and replace water heaters every day. See:
